Raspberry Pi has arrived
I received a Raspberry Pi, so I made a case to put the board.
(Photos of cases and the PCB are below)
This photo is a picture of the box that contains the Raspberry Pi PCB.
I forgot the SD card slot, because Too much to worry about the upper surface of the RPi PCB, So I cut with ultrasonic cutter.
Otherwise it seems good.
I used some Surplus in my house, so There is a difference at the height.
CAD File and Cutting File Download
DXF File (.zip) ·
Cutting File (.zip)
After extracting the files, the files are four of the side plates (8 file each)
[ SIDE No.1 _ No.2 . Extension ]
No.1 shows which plate.
If No.2 is 1, the data make a hole of the part.
If No.2 is 2, the data cut off both ends of the plate.
Please use the 3mm thick plate, because the cut depth is 2.7mm, and I used a 2mm End-mill.
Plate (do not even need about 50mm) is sufficient for more narrow.
Please add a SD card slot.
Holes cut into large, to avoid hitting the terminal, so it is possible to use more thin end-mill cutter or leather cut.
The lower plate are used some surplus. (appropriate size)
You can make with right size, but the cables and terminals are heavy, so Please cut the width with a little larger, will Stabilize.